| Keep BMF | Hello! Welcome to BMF Hardware！ Log in | Register |

  Resins for wire cut EDM machine can use more than a month in general. When flow of resins for wire cut EDM machine is normal but the value of conductivity decline, it’s time to consider to supply or replace resins for wire cut EDM machine.
  Resins for wire cut EDM machine replacement procedure is as follows: (1) shut down wire cut EDM machine and confirm the auxiliary pump has stopped working.  (2)  Loosen the star knob counterclockwise ① To remove the cylinder cover. ② Unscrew the copper nut. (3) Unscrew the M6x50 screws under fastening ring. (4) To remove the barrel of resins for wire cut EDM machine from its seat and to drain invalid resins for wire cut EDM machine, paying attention to clean strainer. (5) Pour 19 liters new resins for wire cut EDM machine. (6) Clean cartridge cover O-ring and wipe little grease on it. (7) Install them in reverse order. (8) Set the conductivity value you need on the screen. If you want more information about EDM wire cut accessories usage and wire EDM consumables please concern Kenos official website.