| Keep BMF | Hello! Welcome to BMF Hardware！ Log in | Register |

    KENOSDG here to explain to you how to replace the Mitsubishi EDM filter.
    When Mitsubishi EDM filters to replace it?That depends on the gauge cartridge or clean the tank.Filter pressure gauge when normal use, the pressure range of about 1.2.
When the pressure gauge pointer is close to 2, to replace the Mitsubishi EDM filter.
If the flow of clean water overflow tank is too small, then this situation also need to replace the Mitsubishi EDM filter.
    So how to replace the wire cut filters?

    First, shut down and confirmed Mitsubishi EDM machine has completely stopped working.
    The second step, remove the Mitsubishi EDM filter fittings.
    The third step is to bring Mitsubishi EDM filter above the handle.
    The fourth step is to remove the bad cartridge and put a new cartridge, connect Mitsubishi EDM filter connector.
    The fifth step, open the Mitsubishi EDM circulating pump, carefully check the pipe connections and fittings where there are no leaks, no on can be used directly on the connectors otherwise good.