| Keep BMF | Hello! Welcome to BMF Hardware！ Log in | Register |

What does wire cut fixtures include? Generally for someone who work on wire cut fixtures should feel that the easiest parts to be broken should be the guide wheel bearings, wire cutting conductive block, molybdenum wire, so for working on wire cut fixtures friends should to pay attention to the wire cut fixtures if it still can use when you feel something wrong in running EDM machine. If it is broken, it should be installed a good one instead. Below Kenos writer will show you some methods to install wire cut fixtures-diamond wire guides.
The first step in the copper sleeve bearing flat on the inside;
The second step of the installation guide wheel tool jacket out of a small part of the precession of the copper jacket, jacket bearing the coat to withstand copper has been the top in the end, this procedure is also another tool to another bearing top in the end;
The third step in the introduction to the tool handle to make sets of rotating inner sleeve bearings to withstand, note that this step should be forced to withstand moderate just another set of tools to withstand this procedure within the bearing, the introduction into
The fourth copper sleeve bearing hole and then gently tap stand fully in place until the introduction;
The fifth step with two hex wrench to tighten the screws on it.
The above is how to install wire cut fixtures-diamond wire guides, do you learn a little? If you have any question about wire cut fixtures-diamond wire guides please don’t hesitate to contact kenos.